За да коментирате, моля, влезте в профила
си!
Имама такъв въпрос, номерацията на снимките в картата, може ли да се нулира, и откъде. Пробвах възможностите на фотоапарата, но не успях. Става въпрос за НР М407. Предварително ви благодаря.
Порови се из настройките на фотоапарата. Трябва да има нещо като "Remember picture counter", което е включено. Изключи го. Разбира се, след това изтрий всички снимки от картата и тогава започни да снимаш.
И аз съм същият апарат и не мога да нулирам номерацията на снимките Ilieva ако успееш пиши ми как си успяла , благодаря ти предварително !
Погледнете дали нямате някъде едно малко бутонче "Reset", ако не - значи търсете из настройките!
не можах да го открия даже и на инфото на сайта НР
Това го пише в manual-а, който се download-ва от страницата на HP.
Resetting the Camera
If your camera does not respond when you press any buttons,
try resetting the camera as follows:
1 Turn off the camera.
2 If you have an optional memory card installed, remove it.
(Although removing an optional memory card is not
necessary for performing the reset, it eliminates the memory
card as a possible cause of the problem.)
3 Reset the camera by removing power from it as follows:
• If you are powering the camera with only batteries, open
the Battery/Memory card door and remove both
batteries for approximately 5 seconds.
• If you are using only an optional HP AC power adapter
to power the camera, disconnect it from the camera for at
least 5 seconds.
• If you are using both batteries and the HP AC power
adapter, remove both for at least 5 seconds.
4 Reinsert the batteries and close the Battery/Memory card
door, and/or reconnect the HP AC power adapter to the
camera.
5 After verifying that the camera works without an optional
memory card, reinsert the card if you have o
Resetting the Camera
If your camera does not respond when you press any buttons,
try resetting the camera as follows:
1 Turn off the camera.
2 If you have an optional memory card installed, remove it.
(Although removing an optional memory card is not
necessary for performing the reset, it eliminates the memory
card as a possible cause of the problem.)
3 Reset the camera by removing power from it as follows:
• If you are powering the camera with only batteries, open
the Battery/Memory card door and remove both
batteries for approximately 5 seconds.
• If you are using only an optional HP AC power adapter
to power the camera, disconnect it from the camera for at
least 5 seconds.
• If you are using both batteries and the HP AC power
adapter, remove both for at least 5 seconds.
4 Reinsert the batteries and close the Battery/Memory card
door, and/or reconnect the HP AC power adapter to the
camera.
5 After verifying that the camera works without an optional
memory card, reinsert the card if you have o
За да коментирате, моля, влезте в профила си!